30
Tiki medical – ENGLISH
4.3 Put the Tiki medical mask on
1. If not already done so:
a. Read the user manual, entirely
b. Prepare the mask as to the procedure:
3.2 Prepare the mask for use on page 25
c. Charge the battery as to the procedure:
4.1 Charge the batter(y)(
ies
) on page 28
2. Before use,
a. Calibrate the blower as to the procedure:
4.4 Calibrate the blower on page 31
b. Test that the seal of the mask is tight as to the procedure:
4.6 Testing the mask during use on page 32
3. Ensure that the mask is cleaned as to the procedure:
5.1 Cleaning the Tiki medical mask on page 35
4. Check the mask for mechanical integrity, if the Tiki medical mask is not ok, either
perform the procedure at: ·
5.4 on page 38 or dispose the mask as to: 6 Disposal on page 39
5. Obey the safety indications in chapter 1 and specific to paragraph:
1.3 Before use on page 5
6. As necessary, tighten long hair in a hair-knot
7. Loosen the straps of the harness a bit
8. With one hand, hold the outer front of the mask, refer to figure 9
9. With the other hand, hold the inner part of the harness, refer to figure 9
10. Pull with both hands the mask to its widest stretch
11. Hold both hands with the mask above the head and bring both hands down:
the mask in front of the face and the harness to the back of the head
12. Position the front of the mask to a comfortable position on the face
13. Tighten the straps of the harness again from top to bottom, refer to figure 10.
Do this to ensure a tight seal between the mask and the face of the user, please
note that over tightening makes the mask uncomfortable.