TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-7000 Installation & Operating Instructions
TiL 05RE375 Rev n/c Issue 13
3-20
3.19.3 OPERATING INSTRUCTIONS
Control of the S200-SG11 satellite gateway is provided by a series of menus under the
main function menu. To open the main satcom menu, press [
FUNC
] and then press [
6
]. The
following selections are available:
1 = Voice Call
Press 1 to initiate the sat phone call menu.
2 = Text Message
Press 2 to for outgoing text message menu.
3 = GPS info
Press 3 for the automated position reporting menu.
* = PRG
Press * for the download menu
Voice Call
When the voice call menu is selected, you can either select one of ten
preset phone numbers by pressing 0 through 9 or you can enter a new
number by pressing [
#
] followed by the number. Dial “001” then the area
code followed by the number. The leading zeros are required by the Iridium
satellite system. Rotating the knob will scroll through the pre-programmed
phone numbers. After the number is selected or entered, press [
*]
to
initiate the phone call. Pressing [*] again will terminate the call. Pressing
[
HOME
] at anytime will bring you to the previous menu.
To answer an incoming phone call (as indicated by a
flashing symbol
and
the
bottom line of the display flashing
along with a ringing sound in the
headset) press [
FUNC]
then [
6]
and the incoming call menu will appear.
Press [*] to answer the call or [
#
] to reject the call.
Text Message
When this menu is selected, you must select one of ten pre-programmed
messages by pressing a number key [0-9] as indicated by the
>
to the left
of the option. Rotating the knob at this point will scroll through the
available messages. The message selected will show for a few seconds
then the menu will return. If it is desired to see the message for longer,
press [
#
] and the message will stay until [
#
] is pressed again. To move the
>
to the next option, press the knob. Then press a number key [1-5] to
select one of five pre-programmed email addresses. Again, the knob can be
used to scroll through the email addresses. Press [
*
] to send or press
[
HOME
] to return to the previous menu.
GPS Info
The current position, direction and speed of the aircraft will be displayed.
The time since the last position report is displayed at the bottom. Position
reporting is normally updated automatically but a manual update can be
sent by pressing *. Press [
HOME
] to return to the previous menu.
When the radio in normal operating mode, an indicator will flash on the
bottom line for a few seconds when an automated position report is
occurring.
PRG
Pressing the [
*
] key will invoke the download function. The pre-
programmed messages, email addresses and phone numbers can be
downloaded into the radio using Technisonic’s MultiTDP software.
Summary of Contents for TDFM-7000
Page 56: ......
