64
High levels of ambient light such as natural sunlight or energy efficient fluorescent lights should be avoided
when manually programming the remote control.
Any button other than the device buttons TV, SAT and DVD and the SET button can be manually programmed.
1
Place the original remote control and the learning remote control roughly 10 mm apart facing ‘head-to-head’
with each other.
2
On the learning remote control press and release the required device button, TV (TV), satellite (SAT) or DVD
recorder/player (DVD) as appropriate.
3
Press and hold the SET button on the learning remote control until the red light lights and remains lit. The
remote control is now in learning mode.
If the red light does not turn on, go back to step 2 and try again.
4
On the learning remote control press and release the button that is to be programmed. The red light will
flash rapidly.
5
On the original remote control, press and hold the button that is to be learned. When the red light on the
learning remote control
flashes three times and then remains lit
the code has been learnt. If the
red light does not flash, repeat steps 4 and 5.
Note: If step 5 is not completed within 15 seconds the learning remote control will exit learning mode and
the light will stop flashing.
6
Repeat steps 4 and 5 to program other buttons.
7
Once the required buttons have been programmed press the
SET
button again on the learning remote
control to exit learning mode.
Manually Programming a Button
Deleting Programmed Buttons
1
Press and release the appropriate device button TV (TV), satellite (SAT) or
DVD recorder/player (DVD) to select which device’s programs are to be deleted.
2
Press and hold the chosen device button together with SET button until the red light flashes three times.
3
All of the programmed buttons for the chosen device have now been cleared of their programming.
Deleting programs from buttons does not delete any four digit brand code which has been entered.
