4
5
Unpacking your Mirage
Please note –
A technically competent person should carry out the
installation of your Mirage.
Unpacking your Mirage
Unpacking your Mirage
Carefully remove the unit from the packing and lay it mirror side down on a horizontal
surface which has been protected to ensure that the mirror does not
get scratched.
The plastic film protecting the mirror should be left in
place until the unit is fully installed.
Remove the screw cap and screw from each fixing
point on the side of the wall frame as shown.
The screws and caps must be retained as
they need to be replaced in the fixing points
to complete the Mirage installation.
The Mirage kit consists of:
1 wall frame
1 mirror frame
1 AC/DC adaptor with integral 4 metre lead and 2 AC leads
1 waterproof remote control
1 remote control holder
1 standard remote control
1 Mirage instruction manual.
☛
If any items are missing,
contact the dealer that
supplied the Mirage.
Move the wall frame in the direction of the arrows as shown below to separate the wall frame from the
mirror fame leaving the mirror frame face down.
Screws
and
screw
caps
Once both screws have been removed the
wall frame can be removed by sliding it off
the hinge pins as shown on page 5.
Lift the wall frame
away from the
mirror frame.
Move the
frame down until
the hinge pins are clear
of the hinge.
Screw and
screw cap
Wall
frame
Mirror
frame
away from th
mirror fram