Timberk SWH FSM1 100 V Instruction Manual Download

Page: 3 / 36

www.timberk.com • electrical storage water heater

1. Completely automatic control: automatic water heating, continuous auto-

matic water temperature control.
2.

DROP Defense

– leakage protection and protection against surplus pres-

sure within a tank (pressure safety valve).

HOT Defense

– two-stage overheating protection (thermostat and tempera-

ture limiter).
ALL PROTECTION SYSTEMS ARE RELIABLE AND SAFE.
3. Pipes of heating elements are designed taking into account high heat load:

safe and reliable, with an increased service life.
4. NON CFC urethane foam insulation of increased thickness: excellent heat

A number of precautions is to be observed upon operation of the fan heat-

er. Improper operation as a result of ignoring precautions may harm health

of the user and other people, as well as damage their property.
1. Any electrical appliance must be supervised when in operation, espe-

cially if there are children nearby. Make sure children do not touch the ap-

pliance.
2. Prior to installing the water heater, not connecting it to electrical main,

check and make sure the outlet for the water heater has a ground pin and

if it is properly earthed. If there is no earth circuit in your electrical main then

operation of the water heater is dangerous for your life.
3. Connect the water heater only to 220-230V, 50Hz main. If necessary,

find out parameters of your mains at power suppliers.
4. To prevent overheating and risk of fire, as well as damage of internal

electrical main, do no modify the power cord’s length and do no connect

the water heater through electrical extenders.
5. It is forbidden to switch on the water heater if it is not filled with water or

if water cannot go through a pressure safety valve.
6. Never use the water heater if it is broken.
7. Do not remove the water heater cover when it is in operation.
8. Immediately unplug the water heater from electrical main if strange

sounds, odor or smoke are coming from it.
9. Always unplug the water heater from electrical main during a thunder-

storm.
10. Prior to cleaning and maintenance of the water heater unplug it from

electrical main. Cleaning and maintenance must be performed in compli-

ance with instructions of this operation manual.
11. Do not use hazardous chemical substances to clean the water heater

and prevent their contact with the appliance.
12. To prevent electrical shock the damaged power cord must be replaced

only in manufacturer’s authorized service centers by qualified specialists.
13. To prevent electrical shock do not place the power cord nearby heating

devices and flammables or combustibles.
14. Do not press buttons on the control panel of the water heater and its

remote controller (for some models) otherwise but by your fingers.
15. Since temperature of water in the water heater can reach +75°C, when

it is in operation you should not place your body parts under hot water at

2. PRECAUTIONS

the first run.
To prevent burns you should adjust the temperature of the discharging

water.
16. Do not use the water heater for purposes not specified by this oper-

ation manual.
17. Do not use the water heater in an explosive or corrosive environment.

Do not store gas and other volatile flammable liquids next to the appliance

– it is very dangerous!
18. It is forbidden to make alterations in the design of the water heater or

modify it.
19. Any service operations must be performed by a specialized organisa-

tion and qualified specialists. Improper installation may cause voiding of

guarantee maintenance.
20. The water heater is not intended for use by children and persons with