Timberk THU UL 05, Instruction Manual

5

www.timberk.com

electric humidifier

7. Operation of the unit

7.1 Switching on the unit

Connect the unit to electric mains. Fill the tank with water in advance.
A musical signal will be given when the unit is connected to a power supply 
source.
Press  On/Off  button (Power), a musical signal will be given and the unit 
will automatically start operating.

AUTO   mode  will  be  shown  on  the  display  screen  and  steam will  start 

coming out of the atomizer.
The display screen will show current air humidity and the warm atomizing 
mode will be switched on automatically.
Ten  seconds  after  switching  of  the  device  a  light  atomizing  indicator 
(preparation for operation) will be illuminated and then will go out.
At the very beginning of this operation the atomizing level could seem 
unstable which is caused by the temperature difference and water quality. 
It  will  take  some  time  for  water  to  transform  into  steam  inside  the 
atomizer s  nozzle  and  this  process to be  stabilized.  In  10-25  minutes of 
operation the atomizing level will be gradually stabilized.
Heating of steam will take about 10-20 minutes.

I

mportant!

1. To prevent an electric shock, prior to dismantling the device 
(removing the tank), unplug the device from electric mains! 2. Do 
not fill the tank with liquids other than tap water.
Other composition of liquids has an adverse effect on internal 
parts and results in a failure.
3. Do not fill the device or the water tank with such additives as 
essential oil, flavoring substance, detergent, chemical medical 
products, warm water (over 40°), etc.
Otherwise the water tank and internal parts of the unit will be 
damaged and be broken.
4. Do not fill water directly into the internal part of the unit or the 
atomizer.
Water inside the unit may result in failure of the device.
5. Do not hit and do not throw the water tank. It can be damaged 
which will result in water leakage. Do not use the unit in case the 
tank is heavily hit.
Contact a maintenance service or maintenance and repair station 
immediately.
6. Every day fill the tank with pure water and keep the unit clean.

Important!

At first or repeated use of the unit even with full tank the water level 
indicator, showing there is no water, will be illuminated on the display 
screen. It happens due to the fact that it takes some time for water to flow 
from the tank to a water groove.
The unit will automatically start operating in 2-5 minutes.
In case if all water in the tank is used, the unit will be switched off and a 
sound signal will be given prior to it and the  water level  indicator will be 
illuminated. 
Add water in accordance with the manual for further use of the unit.

7.2 Automatic operation mode

A temperature and humidity sensor is installed inside the humidifier, when 
the  unit  is  switched  on  or  the  automatic  operation  mode  is  selected  it 
allows  the  unit  to  independently  achieve  the  most  favorable 
humidification level depending on room air temperature and humidity.

Table

2

.

22-24°

20-21°

60%

50%

55%

>25°

65%

<19°

Setting of the automatic operation mode

(level of favorable humidity)

Room air temperature

In the automatic mode the atomizing level is set in accordance with the 
difference  between  levels  of  measured  and  nominal  humidity.  The 
atomizing level in automatic mode:

Table

3

.

<3%

4-15%

Moderate level (normal power)

automatic switching off

Low mode (low power)

Current humidity level

exceeds the favorable one

Hight level (maximum power)

>16%

Atomizing frequency

(intensity a atomizer level)

Difference between levels of

favorable and current humidity

ENGLISH