W415-1477 / A / 10.19.16
8
EN
2.4 GENERAL
INFORMATION
Thank you for purchasing a Wolf Steel Ltd. Pellet Appliance. This appliance is designed for use with Pelletized
Wood Only.
Please read this entire manual before installation and use of this pellet fuel-burning room appliance. Failure to
follow these instructions could result in property damage, bodily injury or even death.
Keep this manual handy for future reference.
This Pellet Appliance, when installed, must be electrically grounded in accordance with the local codes, or in
the absence of local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA
70 National Electrical Code in the United States.
This appliance will not operate using natural draft or without a power source for the blower systems and fuel
feed system.
These appliances are equipped with levelling screws that penetrate the front corners of the fi rebox. If these
screws are missing it will have a negative infl uence on the performance of this appliance. Ensure that the
levelling screws are tightened into position.
The protective wrap on plated parts is best removed when the assembly is at room temperature but this can be
improved if the assembly is warmed, using a hair dryer or similar heat source.
If the appliance is installed directly on carpeting, vinyl tile or other combustible material other than wood
fl ooring, the appliance shall be installed on a non-combustible hearth pad extending the full width and depth.
4.5B
2.4.1 FUEL
This appliance is designed to burn wood pellet fuel. In addition, a corn/wood pellet mixture with a maximum
50% corn can be burned. Burning any other fuel, that is not approved for use with this appliance, will void the
warranty.
Important: The corn/wood pellet mixture needs to be mixed evenly before being put into the hopper.
