16 / 45
SAFE WORKING
TW PTO S426
24.06.2019
The TW PTO S426 is subject to large vibrations during the normal course of operation. Consequently there is always a
possibility that nuts and bolts will work themselves loose. It is important that periodic checks are made to ensure the
security of all fasteners. Fasteners should be tightened using a torque wrench to the settings listed below .
Uncalibrated torque wrenches can be inaccurate by as much as 25%. It is therefore essential that a calibrated torque
wrench is used to achieve the tightening torques listed below.
CHECK FITTINGS
Size Pitch Head Torque Ibft Torque Nm
Hammer Locating Bolts M8 Standard 6 mm Allen Key 31 42
Anvil Bolts M16 Standard 14 mm Allen Key 175 237
Drum Shaft Retaining Bolts M16 Standard 24 mm Hex 90 122
Funnel Retaining Nuts M12 Standard 19 mm Hex 60 80
General M8 Standard 13 mm Hex 17 23
General M10 Standard 17 mm Hex 34 46
General M12 Standard 19 mm Hex 60 80
SPARES
Only fit genuine Timberwolf replacement screws and shredder spares. Failure to do so will result in the invalidation of the
warranty and may result in damage to the shredder, personal injury or even loss of life.
Product name: Copper Ease.
Copper Ease contains no hazardous ingredients at or above regulatory disclosure limits, however, safety precautions
should be taken when handling (use of oil-resistant gloves and saftey glasses are recommended - respiratory protection
is not required). Avoid direct contact with the substance and store in a cool, well ventilated area avoiding sources of
ignition, strong oxidising agents and strong acids. Dispose of as normal industial waste (be aware of the possible
existance of regional or national regulations regarding disposal), do not discharge into drains or rivers.
In case of fire:
in combustion the product emits toxic fumes, extinguish with alcohol or polymer foam, carbon dioxide or
dry chemical powder. Wear self-contained breathing apparatus and protective clothing to prevent contact with skin and
eyes.
FIRST AID
Skin contact:
there may be mild irritation at the site of contact, wash immediately with plenty of soap and water.
Eye contact:
there may be irritation and redness, bathe the eye with running water for 15 minutes.
Ingestion:
there may be irritation of the throat, do not induce vomiting, wash out mouth with water.
A safety data sheet for this product can be obtained by writing to the manufacturer at the
following address: Comma Oil and Chemicals Ltd., Deering Way, Gravesend, Kent DA12 2QX. Tel: 01474
564311, Fax: 01474 333000.
COPPER EASE SAFETY INFORMATION
Summary of Contents for TW PTO/S426
Page 1: ...timberwolf uk com INSTRUCTIONMANUAL TW PTO S426 SHREDDER ...
Page 25: ...TW PTO S426 22 45 DECLARATION OF CONFORMITY 24 06 2019 ...
Page 26: ...23 45 IDENTIFICATION PLATE TW PTO S426 24 06 2019 EXAM PLE ...
Page 29: ...26 45 ELECTRICAL PARTS LOCATOR TW PTO S426 24 06 2019 Date Last Modified 27th July 09 ...