PH
TIMBERWOLF
TW S426TDHB
22
SERVICE INSTRUCTIONS
NOTE: This should be done every 50 hours. In dirty or dusty conditions or during periods of hard
work it should be done more frequently. If the slides become dry the top roller will tend to hang
up and the pulling-in power of the roller will be much reduced. Excessive wear will ensue.
2
The jack stand requires intermittent greasing to maintain a smooth operation.
1. Brush off dirt with a stiff brush.
2. Apply grease liberally to screw thread using a brush.
3. Wind mechanism up and down a couple of times to ensure grease has covered all surfaces.
1.
Remove the top roller box guard.
2.
Remove the nearside roller box guard.
3.
Apply multipurpose grease directly to the slide
surfaces indicated.
DO NOT USE GRAPHITE BASED
GREASE.
4.
Refit both the roller box guards.
1.
Remove the top roller box guard.
2.
Locate the grease nipple indicated.
3.
Use a pump action grease gun to apply a generous
amount of grease to each roller drive.
DO NOT USE
GRAPHITE BASED GREASE.
4.
Refit the top roller box guard.
1.
Remove the discharge tube.
2.
Apply multipurpose grease to surface shown.
3.
Refit discharge tube.
2
NOTE: This should be done regularly. In dirty and dusty conditions or during periods of hard
work it should be weekly. If the bearings and splines are allowed to run dry premature wear will
occur resulting in a breakdown and the need for replacement parts. This failure is not warranty.
Early signs of insufficient grease includes squeaking or knocking rollers.
2
GREASE THE ROLLER SPLINE AND BEARING
GREASE THE ROLLER BOX SLIDES
GREASE THE JACK STAND
GREASE THE DISCHARGE FLANGE
ENGINE SERVICING
All engine servicing must be performed in accordance with the Engine Manufacturer’s Handbook
provided with the machine.
FAILURE TO ADHERE TO THIS MAY INVALIDATE WARRANTY AND/OR
SHORTEN ENGINE LIFE.
