TIMBERWOLF
TW SX200
12
OPERATING INSTRUCTIONS
The engine speed is controlled by the horizontally adjustable lever
shown in the drawing. With the throttle lever in the FAST position the
machine is ready to chip. It MUST be fully pushed to the left to achieve
a suitable working speed. If no wood is to be chipped for a few minutes
the throttle should be returned to the idle position.
ENGINE CONTROLS - DIESEL MODELS
0
1
2
HOURS
0 0 0 0 0 0 0
IT IS ESSENTIAL TO CARRY OUT THE FOLLOWING TESTS
to check safety equipment - this sequence
of tests will only take a few seconds to carry out. We recommend that these tests are carried out daily.
Observing the function as described will confirm that the safety circuits are working correctly. This is also
a good opportunity to remind all operators of the control and emergency stop systems.
BEFORE USING THE SHREDDER- DIESEL MODELS
STARTING THE ENGINE- DIESEL MODELS
STOPPING THE ENGINE- DIESEL MODELS
ENSURE throttle lever is in the slow (tortoise)
position.
INSERT key. Turn to heat.
HEATER LED comes on.
WAIT FOR HEATER LED TO GO OUT.
TURN key to engage starter motor.
RELEASE key once engine starts.
0
1
2
HOURS
0 0 0 0 0 0 0
HOURS COUNTER
START
HEAT
OFF
ON
0
1
2
MOvE the throttle lever to the ‘Tortoise’ to reduce the engine speed to idle.
LEAvE the engine running for 1 minute.
TURN the power switch to position 0. The engine should stop after a few seconds.
REMOvE the ignition key.
For more detailed information refer to the Engine Owner’s Manual
3
1
2
PRESS THE GREEN
BUTTON
THE IN-FEED
SHOULD TURN FORWARDS
PRESS THE RED
SAFETY BAR
THE IN-FEED
SHOULD STOP
PRESS THE BLUE BUTTON
THE IN-FEED SHOULD TURN
BACKWARDS ONLY WHILE THE
BUTTON IS PRESSED
WITH THE ENGINE RUNNING AT FULL SPEED
Do not engage starter motor for more than 20 seconds - allow one minute before attempting to start.
Investigate reasons for failure to start.
Do not continuously crank engine.
Summary of Contents for TW SX200
Page 28: ...TIMBERWOLF TW SX200 27 IDENTIFICATION PLATE EXAMPLE...
Page 36: ...Blank page...
