32
TO FEED OIL
1.Remove the filler cap.
2.Fill fuel until the fuel indicator points to “F”.
3.Do not fail to stop up the filler hole with the cap.
4.Before you feed oil, extinguish the heater.
IMPORTANT NOTICE REGARDING FIRST IGNITION OF HEATER:
The first time you light your heater there may be some odor due to the burning off of oils used in the
manufacturing process. To avoid this you may wish to burn the heater outside on a calm and windless day.
If it’s windy consider a porch or garage or other room where the windows can be open to disperse the
odor.
TO IGNITE
1. When you are going to use the heater for the first time
，
you will feed oil and wait about ten minutes
until the wick is soaked with fuel.
2. Lit with a match
a. Lift the wick by turning the wick adjust handle knob clockwise. b. Tilt the chimney by pinching the
chimney knob. c. Light the wick with a match at its two or three spots.
d. Turn the chimney using the chimney knob, thereby setting the chimney property on the burner.
IMPORTANT NOTICE REGARDING FIRST IGNITION OF HEATER:
The first time you light your heater there may be some odor due to the burning off of oils used in the
manufacturing process. To avoid this you may wish to burn the heater outside on a calm and windless day.
If it’s windy consider a porch or garage or other room where the windows can be open to disperse the
odor.
Summary of Contents for 102827423
Page 10: ...10 Kuva 1 Kuva 2...
Page 11: ...11 Kuva 3 Kuva 4...
Page 12: ...12 kuva 5 Kuva 6 Kuva 7...
