- 21 -
INSTALLATION
Input cable connection (enclose installing diagram)
1.
Every machine has been disposed a power cable which must be connected to
coordinated voltage class in compliance according to input voltage of cutting
machine .If cutting machine whose power voltage is 220v is connected wrong to AC
380v ,that will cause components of inter-machine are burned up .
2.
Make sure power cable is connected to power switch reliably and prevent from
oxidizing.
Make sure power voltage is inside the waved range.
Output cable connection
1.
Make sure tube of pressed air is connected to copper connector by high pressure
rubber tube firmly.
2.
Make sure copper screw of another end of torch is connected to electrify integration
terminal then tighten them clockwise relation (prevent from leaking gas) .Mobile
plug of another end of grounding cable pincer is connected to positive terminal of
front panel then tighten it .
3.
Make sure air plug of torch is connected to switch connector of panel (If it is
arc-supporting cutter, arc-supporting cable of torch is connected to terminal of
arc-supporting.)
CHECK
1.
Check if cutting machine is grounded reliably according to standard.
2.
Check if all connectors is connected firmly.
3.
Check if power voltage is correct.
OPERATION
1.
Open the power switch of front panel ,make the power switch is in “on” position .At
this time indicator of power switch is on .Screen will show the current volume .
2.
Adjust the gas pressure and make it is adequate to machine, open the valve of
pressed air.
3.
Press the control knob of torch ,electromagnetic valve is starting ,sound of HF
arc-striking can be heard and burner of torch should flow out gas (Burner of
arc-supporting cutter should spurt fire )
4.
Make sure cutting current is adequate to machine according to thickness of cutting
piece.
5.
It is 1mm from copper tip to work piece (it is further if it is arc-supporting
cutter .),press knob of torch and burn and strike arc ,sparks of HF arc-striking will
diminished immediately .User can begin to cut .