9
10
9.2. Programming Across Midnight
10. Modifying or Adding Programmes
11. Advance
Enter the programme on time as above.
Enter the programme off time as 00:00
Enter the first programme on time for the next day as 00:00
Enter the required programme off time.
Note: for 24 hour the on period for programme 1 must start 00:00.
Press Prog and hold for 3 seconds. Whilst holding, the word hold will appear
on the display.
After 3 seconds the display will show the programming mode screen.
This will be in the mode in which it was last programmed. For instance if
it was programmed in 5 + 2, then it will show Mo Tu We Th Fr. Either accept this,
press Prog, and review the times programmed for this mode by pressing Prog, or
press Adv or Boost to change the mode, and then press Prog to review the times.
In this case, either to Sa Su, or to 7 day or to individual days.
In operating mode Adv advances the programme to the next change. If the output
is off, it will change the output to on, until the next programmed off time. If the
output is on, it will change the output to off, until the next programmed on time.
A second push of the Adv button selects a permanently on mode, where the output
is on, irrespective of the programming.
A third push of the Adv button selects a permanently off mode, where the output
is off, irrespective of the programming.
A fourth push of the Adv button returns the unit to operating mode, where the
output will conform to the programming.
Note: If the unit was programmed as a 5 + 2 then changing the mode to
any other mode other than Sa Su may blank any previous programming.
The same applies for changing from any other mode, changing from the mode
it was last programmed in may blank the previous programme.
Review times and adjust as necessary as described in section 8.
