3
1 2 3 4 5 6 7
Setting clock
Programme 1 ON
Programme 1 OFF
Programme 2 ON
Programme 2 OFF
Programme 3 ON
Programme 3 OFF
Programme 4 ON
Programme 4 OFF
Programme 5 ON
Programme 5 OFF
Programme 6 ON
Programme 6 OFF
Operation Mode
:
:
:
:
:
:
:
:
. . . . . .
. . . .
➔
Programming sequence
Note: Pauses between button presses greater than 1 minute during
programming will result in automatic return to the operating mode.
2. Setting Clock (after reset)
i
Day Setting
- Press <Change> button to advance to the day required.
Day 1 = Monday and Day 7 = Sunday.
ii
Hour Setting
- Press the <Program> button briefly to
select the hours - display shows clock symbol and the
hours digits flashing.
Press the <Change> button to advance the hour
setting. For rapid hours selection press and hold
down <Change> button. (Note: Monday shown as
example of day set.)
1 2 3 4 5 6 7
Release the buttons and the display will fill with its
complete range of characters and then clear to show
clock and day 1 symbol flashing. This procedure is
essential with a new ETU17 and is recommended if
major reprogramming is required subsequently.
You are now in the clock setting mode at the
beginning of the programme sequence
