TMS6002
USER MANUAL
Ref : MN06127
Date : 2019-03-27
Issue : A1
Page: 12/18
Tous droits réservés © TimeLink microsystems
The second line shows the position of the antenna connected to the equipment.
Available actions from this screen are:
•
A long press on the red button excludes or includes the GNSS source into the list of available time
sources.
•
A GNSS Coldstart is achieved by pressing successively red button, left arrow, left arrow, right arrow,
right arrow, green button. Once a cold start has been done, the equipment must be switched OFF and
ON.
3.3.3.1.
IRIGB SCREEN
IRIG-B time is not available
Type: standard status : no signal
Sample screen for IRIGB time source (no signal in that case)
•
A long press on the red button excludes or includes the IRIGB source into the list of available time
sources.
3.3.4.
OSCILLATOR SCREEN
This screen gives information about
•
the measurement of the phase differences between the internal 1PPS and the 1PPS of the time source
•
the computed frequency stability estimator
Est. Stab.=+1.023e-11 PH/TR
PPS/GPS = +012ns
Sample screen of the oscillator
The first line gives the stability estimator, and the mode (here active PHASING/TRACKING).
The second line indicates the estimation of the phase difference between the internal generated 1PPS and the
1PPS of the reference time source.
Est. Stab.=+1.023e-11 HEAT
PPS/GPS = +012ns 10s
Sample screen of the oscillator during the heating period
First line indicates that the oscillator is heating.
Second line indicates the remaining time for the end of heating.
