Figure 7-6 TCP/IP Settings Page
Click Save to save the settings.
NIC Type
Select a NIC type from the drop-down list. By default, it is Auto.
DHCP
If uncheck the function, you should set the IPv4 address, IPv4 subnet mask, IPv4 default
gateway, MTU, and the device port.
If you check the function, the system will allocate the IPv4 address, IPv4 subnet mask, and the
IPv4 default gateway automatically.
DNS Server
Set the preferred DNS server and the Alternate DNS server according to your actual need.
Set EHome Parameters
Set the EHome parameters for accessing device via EHome protocol.
Steps
Note
The function should be supported by the device.
1. Click Configuration → Network → Advanced Settings → Platform .
2. Select Ehome from the platform access mode drop-down list.
3. Check Enable.
4. Set the EHome version, server address, device ID, and the EHome status.
Note
If you select 4.0 as the version, you should set the EHome key as well.
5. Click Save.
46
ULtraFace 331 Face Recognition Terminal User Manual
Page 53 of 68
