Select a peripheral from the drop-down list according the actual situation. You can select from
Card Reader, Extension Module, Access Controller, or Disable.
Note
After the peripheral is changed and saved, the device will reboot automatically.
RS-485 Address
Set the RS-485 Address according to your actual needs.
Note
If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
Baud Rate
The baud rate when the devices are communicating via the RS-485 protocol.
Output Type
If you select Access Controller as the peripheral type, you should set the parameter. The device
will output the card No. or the employee ID to the access controller.
7.5.12 Set Image Parameters
Set the video standard, WDR, brightness, contrast, saturation, and sharpness.
Steps
1. Click Configuration → Image .
Figure 7-13 Image Settings Page
2. Configure the parameters to adjust the image.
Video Standard
51
ULtraFace 331 Face Recognition Terminal User Manual
Page 58 of 68
