Timken ROLLON CTU 220-1I, User Manual

UM-7

Cobot Transfer Unit

Packaging

Transport

Handling and lifting

■

Before handling, read the instructions, especially safety 

instructions, provided in the installation manual, on the 
packages and/or on the dismantled parts.

■

DO NOT attempt, in any way, to bypass handling methods 

and the established lifting, moving and handling points of 
each package and/or dismantled part.

■

Slowly lift the package to the minimum necessary height 

and move it with the utmost caution to avoid dangerous 
oscillations.

■

Make sure you can see properly. DO NOT move the ma-

chine with an inadequate visual field and when there are 
obstacles along the route to the final location.

■

DO NOT allow people to either transit or linger within the 

range of action when lifting and handling loads.

■

Do not stack packages to avoid damaging them, and re-

duce the risk of sudden and dangerous movements.

■

In case of prolonged storage, regularly ensure that there 
are no variations in the storage conditions of the packages.

Correctly connect the lifting devices to the established points 
on the boxes and/or on the packages.

These symbols can be found on the Partly Completed Machin-
ery or on the crate.

Symbol indicating the center of 
mass of the package to handle

Symbol indicating the pick up 
points to use to lift the package

Check axis integrity after shipment

Installation

Every shipment is accompanied by a document (“Packing 
list”) with the list and description of the axes.

■

When a shipment is received, check to make sure that 
the materials received correspond to specifications in the 
delivery document.

■

Check that packaging is perfectly intact and, check that 
each axis is intact.

■

In case of damage or missing parts, contact the manufac-

turer to define the relevant procedures.

■

Fitting out the established location in advance makes it 
possible to avoid wasting the time of installation techni-
cians.

■

Evaluate in advance whether the machine must interact 
with other production units, and that integration can be 
implemented correctly, in compliance with standards and 
without risks.

■

The manager shall assign installation and assembly in-
terventions ONLY to authorized technicians with acknowl-
edged know-how.

■

State-of-the-art connections to power sources (electric, 
pneumatic, etc.) must be ensured, in compliance with rel-
evant regulatory and legislative requirements.

■

State-of-the-art connections, alignment and leveling are 
essential to avoid additional interventions and to ensure 
correct machine function.

■

Upon completion of the connections, run a general check 
to ascertain that all work has been correctly carried out 
and to ensure compliance with requirements.

■

Failure to comply with the information provided might 
entail risks for the safety and health of people, and can 
cause economic loss.