© TIMYO B.V.
TIMYO USER MANUAL EN SKO52021V2
PAGE 14
4.2 Important notes
The electrical system of your e-bike is very powerful. If you notice that the electrical
system is damaged, remove the battery immediately. After a fall or an accident, electrified
parts may be exposed. Please contact your dealer if you have any questions or problems.
Lack of expertise can lead to serious accidents.
Switch off the electrical system and remove the battery pack before carrying out any work
on your e-bike.
Do not clean the e-bike with a steam device, power jet, pressure washer or water hose.
Water can penetrate the electrical components or drive and destroy the equipment.
The operating temperature should be between -15 and +60 °C. The recommended
storage temperature is between -20 and +35 °C.
Perform only the operations as specified in this manual. Do not tamper with or modify the
system. Modules must not be disassembled or opened. If in doubt, consult a specialist dealer.
Replace defective or worn parts, such as the battery, charger and cable with original spare parts
made or recommended by the manufacturer. Failure to do so will invalidate the warranty and/
or manufacturer's guarantee. If non-original or incorrect spare parts are used, the e-bike may not
function properly. If something is defective, contact an official dealer who will carry out repairs using
original parts only.
Incorrect operation of the drive system and changes made to the battery, charger or drive system
can result in injury or costly damage. In such a case, the manufacturer cannot accept liability for
any damage or losses that may have been incurred. Changes to the electrical system may result
in criminal prosecution. This may be the case if the supported maximum speed has been modified.
5
Display Screen and Control Panel
5.1
Overview display screen
DPC18 DISPLAY
1:
Time
display
The time is displayed in the 24-hour system and shows the current
time. The time can be set in
'setting the clock'
.
2: USB charging display
When an external connection is made to the display,
the
symbol is displayed.
3:
Headlight
indication
It will only be displayed when the headlight is switched on.
4: Speed scale display
The scale value corresponds to the digital value.
5:
Mode
select
single trip distance (TRIP) -> total distance ODO -> maximum speed
(MAX) -> average speed (AVG) -> remaining distance (RANGE)
-> energy consumption (CALORIES) -> time (TIME).
6: Battery level display
Current battery value display.
7: Voltage / percentage display
Show the actual level of the battery level; the display mode
can be set in the
'Soc View'
.
8: Speed digital display
Display current speed; speed unit can be set in
'Unit'
.
!
!
!
i
!
1
6
9
11
4
5
2
7
3
8
10
