© TIMYO B.V.
TIMYO USER MANUAL EN SKO52021V2
PAGE 62
6 Battery
We recommend fully emptying the battery the first 3 times and then fully charging it.
6.1
Rear carrier battery
KE280/HH280
6.1.1 Operating the battery lock - rear rack
To attach the battery pack to the e-bike, follow the steps below:
■
Gently slide the battery into the battery slot
■
Switch on the battery with the key, turn the key horizontally to "on"
■
Always remove the key from the battery during operation, because the key is not locked in
the "on" position
■
The battery itself is locked in the "on" position
■
Turn the key to "off" to switch off the battery
■
To unlock the battery lock push the key lightly into "push", and turn the key through
to "unlock". Remove the key from the lock. You can now remove the battery from the battery
slot by pulling the battery out of the rear rack
6.1.2 Removing the battery from the e-bike - rear rack
Use the key on the battery lock.
■
Insert the key into the lock on the left side of the front of the battery and gently pull up the key
■
Remove the key from the battery
■
Pull the battery pack backwards to remove it from the battery slot
6.1.3 Installing the battery in the e-bike - rear rack
The battery can be slid into the battery slot under the carrier. You hear a click at the end to check that
the battery is in the right place.
6.1.4 Charging - rear rack
The battery should be charged with the charger provided. The battery can remain in the e-bike
during charging, but it can also be removed from the e-bike. Charging takes place via the regular
electricity grid. In some cases, you will need to turn on the battery before the battery can be charged.
The charging port is located under the cover; indicated in red on the picture.
6.1.5 Charge status and capacity
Press the " " button for 1 second so that the battery control system detects the charge status of the
battery to show it on the LEDs for 5 seconds. Press and hold the " " button for 5 seconds so that
the BMS can display the power of the battery on the LEDs for 5 seconds. The battery control system
will then turn off the LED to save energy.
6.1.6 Sleep mode
To avoid damaging the battery discharge, the battery control system puts the battery in sleep mode.
In sleep mode, no function is indicated for technical reasons. Press and hold the " " button for 5
seconds to exit the persistent sleep mode.
.
i
