Operation
27
If no CNG signal was detected a standard voice call will be assumed. The call will
then be forwarded to those telephones configured as receiving telephones for
incoming external calls. The telephone system will try for up to 55 seconds to set
up a connection to an internal subscriber. At the same time the caller will hear a
calling signal generated and sent by the telephone system.
In case an incoming fax had been taken by a telephone this 'call' should be
forwarded to the fax machine at port 4.
With your telephone system 2/8 USB the fax switch will only work with the first
external line.
The fax machine must be connected to port 4 and has to be ready to receive a fax
after 1 or 2 ringing signals.
The fax switch will turn off after 3 unsuccessful attempts. Attempts are treated as
unsuccessful when they were not taken by the fax machine, e.g. when there
is no more paper in the machine.
In case the fax machine busies port 4, e.g. due to an internal call, no fax can be
forwarded. Incoming calls on external line 1 in this case remain unanswered
until the fax machine will release port 4 again.
For sending a fax message code number
for external line access will have to be
dialled or the automatic external line access will have to be programmed for
that port.
The fax switch function can be activated or deactivated from every telephone.
Activate fax switch
1. Pick up handset
You will hear the internal calling signal.
2. Dial code number
.
You hear the acknowledge signal.
3. Hang up.
The fax switch is activated the LED FAX is on.
Deactivate fax switch
1. Pick up handset
You will hear the internal calling signal.
2. Dial code number
.
You hear the acknowledge signal.
3. Hang up.
The fax switch is deactivated the LED FAX is
off.
Only for Switzerland:
