2
INTENDED USE
2.1
Operation limitations
2.1.1
The turnstile must be used in the environment specified in p. 1.1.5 of this
document subject to the specifications listed in section 1.2.
IT IS FORBIDDEN
:
1)
TO MISUSE THE TURNSTILE (See section 1 "DESCRIPTION AND
2)
TO USE THE TURNSTILE UNEARTHED
;
3)
TO USE HEATING PIPES AND RADIATIONS AS WELL AS PIPES OF
4)
TO REPAIR AND ADJUST WITHOUT DEENERGIZATION;
5)
TO RELOCATE THE OBJECTS EXCEEDING THE PASSAGEWAY
WIDTH THROUGH THE TURNSTILE ACCESS AREA;
6)
TO JERK AND IMPACT BARRIER RODS, LED DISPLAY OR OTHER
PARTS THE PRODUCT, WHICH MAY CAUSE THEIR MECHANICAL
DAMAGE;
7)
EXERT FORCE ON LEAVES MORE THAN 400 Н (40 KG) IN
“ACCESS LOCKING” MODE
2.1.2
It is forbidden to use the turnstile:
– at the presence of mechanical rattle in movable parts of the turnstile;
– when metalwork of the turnstile and its components and accessories are mechanically
damaged.
2.1.3
List of special operation conditions
Mean time of the turnstile access (in single access mode) equals to 2,
sec.
The turnstile’s mechanism allows emergency access by means of antipanic device.
The force applied by accessor to barrier rod should not exceed 10
0
/
.
Escape door, portal or pedestrian gate can be installed near the turnstile to increase
the turnstile traffic flow capacity in case of emergency.
2.2
Layout and installation
2.2.1
The turnstile and components of scope of supply to be delivered to installation site in
factory packing. The turnstile to be unpacked only on installation site.
OPERATION");
CENTRAL WATER SUPPLY FOR EARTHING
2.2.2
Preparation of the turnstile for installation (dismounting) and commissioning to be
performed according to this OM with mandatory observation of safety measures specified in p. 2.1
and general electrical safety code.
