13
1.6 Description and operation of controllers as components of the turnstile
1.6.1
Motorized mechanism controller РСВ.201.01.00.00
The controller is designed for acquisition of commands from external control devices
(control panel, access control system etc.) and generation of control signals for swing gate
motorized mechanism
1.6.1.1 The controller is assembled on the (85 х 70mm) board, on which electronic
components and connectors for external connections are mounted.
13 LEDs are installed on the controller board. Their purpose is as follows:.
•
8 LEDs indicate condition of inputs «IN1»
«IN8».
•
«POWER» LED indicates availability of supply voltage 5V;
•
4 LEDs indicate condition of outputs for motor connection.
24 terminals are installed on board: 2 of them are designed for external connections, the
rest are designed for connection to the turnstile units or are standby.
1.6.1.2 The controller technical features are shown in Table 5.
Table 5
Parameter description
Parameter value
1
2
Number of inputs
2
Number of outputs
4
Type of input
logical
Type of output «GRN1», «RED1», «GRN2», «RED2»
open collector
Logical «1» voltage
(3,7
5) V
Logical «0» voltage
(0
1,7) V
Peak voltage applied to inputs «IN1»÷« IN8»
15 V
Peak voltage switched by outputs «GRN1», «RED1», «GRN2»,
«RED2»
30 В
Peak current switched by outputs «GRN1», «RED1», «GRN2»,
«RED2»
2 А
Peak voltage switched by outputs «
-
MG1», «
-
MG2»
50 В
Peak current switched by outputs «
-
MG1», «
-
MG2»
5 A
Peak voltage switched by outputs «MOT1», «MOT2»
27 V
Peak current switched by outputs «MOT1», «MOT2»
≤ 4 А
Controller supply voltage
(10
27) V
Consumption current when outputs «MOT1» and «МОТ2» are OFF
≤0,15 А
Climatic modification and location category according to GOST
15150
-
69
NF4
The controller appearance is shown in
Figure 5.
