15
Table 6
Connector
/ contact
No
Designati
on
Direction
Purpose
Signal parameters and
description
X1/1
IN1
ENTRY
Not applicable
1) logical «0» (0
1,7) V;
2) logical «1» (3,7
5)
V;
3) active level of signal –
logical «0»;
4) voltage on open input ≤
5 V
X1/2
IN2
ENTRY
Not applicable
X1/3
IN3
ENTRY
Selection of turnstile type
X1/4
IN4
ENTRY
Not applicable
X1/5
IN5
ENTRY
Connection of rotor position sensor
X1/6
IN6
ENTRY
X1/7
IN7
ENTRY
X1/8
IN8
ENTRY
X1/9
GND
«
-
» power supply (common wire)
X1/10
GND
X1/11
GND
X1/12
+5 В
EXIT
Not applicable
X2/1
GRN1
EXIT
Not applicable
X2/2
RED1
EXIT
Not applicable
X2/3
GRN2
EXIT
Not applicable
X2/4
RED2
EXIT
Not applicable
X2/5
-
MG1
EXIT
Connection of locking solenoid
winding
1) type of output
–
open
collector;
2) peak voltage on
privacy key
–
50 V;
;
3) peak current of public
key
–
5 A
X2/6
+MG1
EXIT
Connection of locking solenoid
winding (cathode of protective
diode )
X2/7
-
MG2
EXIT
Not applicable
X2/8
+MG2
EXIT
Not applicable
X2/9
MOT1
EXIT
Motor connection
1) voltage
(10 ÷ 27) V;
2)
current ≤ 4 А
X2/10
MOT2
EXIT
X2/11
GND
«
-
» power supply
(common wire)
X2/12
+24 В
ENTRY
«+» power supply
(controller energization)
1) voltage
(10 ÷ 27) V;
2)
current ≤ 4 А
Х3
Х3
ENTRY
/
EXIT
Communication port
1) logical «0»
(0
1) V;
2) logical «1»
(3,5
5) V
1.6.2 Turnstile controller РСВ.112.21.20.00
The controller is designed for acquisition of control commands from peripherals (control
panel, access control system etc.), generation of feedback signals, turnstile LED display control
and motorized mechanism controller control.
1.6.2.1 The controller is assembled on board (104х68) and designed for installation
inside the turnstile body or power supply box. The controller appearance is shown in Figure 6.
19 LEDs are installed on the controller board. Their purpose is as follows:
•
LED “POWER” initiates availability of power supply voltage 5V;
•
LED “OPERATE” initiates operability of microprocessor;
•
7 LEDs initiate state of outputs for peripheral connections “OUT1» ÷ «OUT7”;
•
3 LEDs “SENSOR” initiate state of rotor position sensor;
