21
2 INTENDED USE
2.1 Operation restrictions
2.1.1The turnstile must be used in the environment specified in p. 1.1.4 of this document
subject to the specifications listed in section 1.2.
IT IS FORBIDDEN:
1)
TO MISUSE THE TURNSTILE (See Section 1 "DESCRIPTION
OPERATION");
2) TO USE THE TURNSTILE UNEARTHED;
3) TO USE HEATING PIPES AND RADIATIONS AS WELL AS PIPES
CENTRALOF WATER SUPPLY FOR EARTHING;
4) TO REPAIR AND ADJUST WITHOUT DEENERGIZATION.
5) TO RELOCATE THE OBJECTS EXCEEDING THE ACCESS WAY
THROUGWIDTH THE TURNSTILE ACCESS AREA;
6) TO JERK AND IMPACT ANTICROSSING BLADES, LED DISPLAY OR
PAROTHERSOF
THE
PRODUCT,
WHICH
MAY
CAUSE
THEIR
MECHANICAL DISTORTION OR DAMAGE;
2.1.2 It is forbidden to use the turnstile:
–
at the presence of mechanical rattle in movable parts of the turnstile;
–
when metalwork of the turnstile and its components and accessories are mechanically
damaged.
2.1.3
List of special conditions of operation
•
Mean time of the turnstile access (in single access mode) equals to 2 sec.
•
Escape door, portal or pedestrian gate can be installed near the turnstile to
increase the turnstile traffic flow capacity in case of emergency.
2.2 Layout and installation
2.2.1
The turnstile and components of the scope of supply to be delivered to installation site in
factory packing. The turnstile to be unpacked only on installation site.
2.2.2
Preparation of the turnstile for installation (dismounting) and commissioning to be
performed according to this OM with mandatory observation of safety measures according to in p.
2.1 and general electrical safety code.
2
.2.3 Safety measures:
•
Installation to be performed only by the persons briefed on safety and studied this
manual;
•
Only serviceable tools to be used during the turnstile installation;
•
Connection of all cables to be performed only when power supply is OFF;
•
Cables to be laid in compliance with electric diagram ;
•
The turnstile to be installed by at least 2 installers.
2.2.4
Tools and accessories to be used
(Fig.10)
:
−
puncher;
−
concrete drills (according to diameter of anchors included in the turnstile scope of
delivery);
