38
gases and vapours causing metal corrosion. Air temperature during storage should not be below
+500 С and above +400 С and relative air humidity should not be more than 80% at the temperature
20° С.
5.2 Turnstile transportation
The ready
-
to
-
install turnstile to be transported according to the transportation regulations
related to the relevant mode of transport, such as:
– in railway or special containers;
– in closed vehicles;
– waterborne (in ship’s hold) .
Transportation on open platforms is allowed. In this case the packed turnstile should be
covered with canvas. Air temperature during transportation should not be below -
40°С and above
+50°С.
After transportation or storage of the turnstile at negative temperatures or increased
humidity the turnstile to be kept indoor with normal climatic conditions without original packing
within 12 hours before commissioning:
1)
ambient temperature: + 15°С to +35°С;
2) relative humidity: 45% to 80 %;
3) atmospheric pressure: 84,0 to 106,7kPa (630
-
800 mm
6 DISPOSAL
The turnstile design does not contain materials environmentally hostile and hazardous to
health and special measures are not required for its disposal.
7
MANUFACTURER'S
WARRANTY
AND
TERMS
OF
WARRANTY
MEAINTENANCE
7.1. The manufacturer guarantees good state and declared quality of the turnstile if conditions
of transportation, storage, installation and operation are observed by the consumer.
7.2. The warranty period of the turnstile from the date of sale is
12 months
unless otherwise
specified by agreement.
7.3 During warranty period the Manufacturer undertakes to perform repair or replacement
within 10 days (at the discretion of the Manufacturer) of the failed turnstile or its parts having
proven factory defects (not due to nonobservance of storage, transportation, installation and
operation conditions specified by this OM) preventing further use of the turnstile.
7.4 The Manufacturer does not bear responsibility and warranty liabilities for the turnstile
damage due to nonobservance of the requirements specified by this OM and in case of the turnstile
unintended use.
7.5 Warranty liabilities of the Manufacturer are valid only if sections 3, 4, 5 of this
DATASHEET and warranty coupon are completed as well as the relevant signatures and seals are
available. The turnstile to be repaired only by the authorized service center of the manufacturer with
use of exclusively original spare parts. Warranty liabilities don’t include free
-of-charge arrival of
technical staff to the Customer for repair.
7.6 The relationships between the Manufacturer and the Customer under warranty liabilities
are regulated by the applicable law of Ukraine, concluded purchase contracts and these warranty
obligations.