Page
-13-
Size А4
Installation and Operation Manual
Revision 1.0 2021
ROAD BLOCKING SYSTEMS
Office and Production site:
Tel.:
+380 (44) 291-21-11
14 Promyslova str., 02088, Kyiv, Ukraine,
Fax:
+380 (44) 291-21-02
E-mail:
sales@tiso.global www.tiso.global
BOOM BARRIER OPTIMUS
М10х100
Mounting bracket
М10х16
Barrier Arm
Arm holder
Shaft of mechanism
5) Connect the
(see section 7)
electronic control unit
6) Give the “Open” command to raise the barrier arm from the control panel
to check the verticality.
In the end positions of the barrier (open / closed), the barrier arm must
be strictly vertical and horizontal. Alignment is achieved by adjusting
the positions of the mechanical stops. (see clause 6.4.3).
2) Press by bracket and fix barrier arm by bolts M10x100 (2 pcs);
3) Four M10x16 bolts shall be mounted on the edges of mounting bracket.
6.4 Barrier arm mounting
6.4.1 Barrier arm installation
1) Place the barrier arm on the holder and on the shaft of mechanism;.
Make sure that arm is in a horizontal position
Before installing the barrier arm, it is recommended to connect arm lighting (if arm lighting is
provided in the order (see section 7);
Make sure the barrier arm is in the upright position.
