Page
-14-
Size А4
Installation and Operation Manual
Revision 1.0 2021
ROAD BLOCKING SYSTEMS
Office and Production site:
Tel.:
+380 (44) 291-21-11
14 Promyslova str., 02088, Kyiv, Ukraine,
Fax:
+380 (44) 291-21-02
E-mail:
sales@tiso.global www.tiso.global
BOOM BARRIER OPTIMUS
Always turn off the electricity when setting up the boom barrier!
1) cabinet door to be opened with key from the kit;
2) set the barrier arm in upper position manually using handle of manual control;
3) unlock the drive, unscrew the lever fixing screw;
4) balance the arm by tightening or loosening the balancing spring nut;
5) set the boom at 45° using manual control and check the system balance;
6) lock the drive by tightening the screw of lever fixing.
6.4.2 Arm balancing
џ
Check the condition for correct arm balancing (spring operation):
- in the vertical arm position, the spring is in a free state;
- in the horizontal arm position, the spring is in a tensioned state;
- in the 45° position, arm neither lower nor raise;
џ
If the balance of the system is not achieved and there is a difference in force when arm moving from the
end positions, the arm must be balanced. For this should be done:
The arm is correctly balanced if it moves smoothly, without jerking and remains fixed at the end of
stroke;
the force required to raise the boom from a horizontal position should be equal to the force required to
lower the boom from a vertical position.
The horizontal and vertical line alignment can be adjusted by moving the stops.
45°
1
2
4
3
5
2
