10.1 Rules of operations
To ensure the Boom Barrier continuous and reliable operation it is necessary:
џ
to use the product according to its intended purpose;
џ
all rules specified in this Manual shall be strictly observed during operation;
џ
to provide maintenance and repair of equipment in due time;
џ
to prevent the Boom Barrier operation and maintenance to be performed by unauthorized
persons;
It is forbidden:
to touch the Boom Barrier arm during its operation;
to prevent Boom Barrier raising/sinking;
to initiate movement of vehicles prior to complete Boom Barrier sinking
10.2 Equipment maintenance:
The Boom Barrier maintenance includes preventive measures to be taken according to the established frequency
to maintain Boom Barrier in operational condition, decrease component wearing and prevent faults and
malfunctions.
10.
Boom barrier operation regulations
M type
Frequency
Scope of control/work
1
2
3
Daily
inspection
each shift
Daily maintenance is performed before commencement of work and includes:
- visual inspection of Boom Barrier;
- if required, prompt mechanical troubleshooting, elimination of corrosion and
surface pollution;
- availability of all units and sensors in their proper locations and their
fastening are reliable;
- performance of all sensors and cable integrity;
- Boom Barrier normal operation without jerks and abnormal noises, jamming of
movable constructional elements;
- motor heating (over 70°C).
M-1
monthly
M-1 is performed monthly and includes the following measures:
- measures in the scope of daily inspection;
- elimination of dust and dirt from the Boom Barrier housing and components;
- cleaning of actuators, sensors and actuators;
- verification of sensors fixation reliability and their performance;
- verification of good condition and fastening security of cable connections to
actuators, sensors;
- check of availability and integrity of protective fences and devices.
M-2
semiannually M-2 maintenance is performed semiannually including the following types of work:
- measures in the scope of M-1;
- verification of fastening security of units and devices;
- check of lever tightening;
- check of spring, circuit and relative anchors;
- check of barrier arm balance;
- make sure that at the end of stroke the lever is horizontal and / or upright
position;
- check of operation of control unit and safety devices;
The equipment examination and maintenance to be performed according to
the Schedule and only by the properly qualified professionals.
Table 8
- Boom Barrier maintenance schedule
Page
-22-
Size А4
Installation and Operation Manual
Revision 1.0 2021
ROAD BLOCKING SYSTEMS
Office and Production site:
Tel.:
+380 (44) 291-21-11
14 Promyslova str., 02088, Kyiv, Ukraine,
Fax:
+380 (44) 291-21-02
E-mail:
sales@tiso.global www.tiso.global
BOOM BARRIER OPTIMUS
