1.
General safety provisions
џ
It is forbidden to make changes to the arrangement of equipment and use of materials and
components that are not included in scope of delivery and are not provided for in this
Manual.
џ
Safety devices shall protect potentially hazardous areas.
џ
In the case of violation of the operating rules and the requirements of the operational
documentation, the boom barrier may pose no hazard to life and health by virtue of high
voltage and moving parts of the product!
џ
Personnel involved in maintenance of existing electrical installations or commissioning,
electrical installation, repair work, maintenance and installation shall be trained to work
with this model of the device! Training shall be carried out at the manufacturer's represen-
tatives' or at the manufacturers' of the product.
џ
Do not allow children and unauthorized persons to stay near operating equipment. The manufacturer shall bear
no responsibility for violation of safety rules.
The Manual should be scrutinized prior to the equipment installation and operation to ensure
the human safety. Safety is not ensured in case of improper operation or use.
џ
TiSO Company ensures its best effort for guarantee and correctness of this Manual and reflecting material
changes in the design. However, a policy of continuous improvement can lead to insignificant differences
between the equipment supplied and the description in this document.
џ
Any actions that are not explicitly listed in these instructions shall be prohibited.
џ
The Manual to be kept for future use.
џ
Transportation of the product shall be ensured only with the barrier arm removed!
1.1
Instructions for installers:
1. For your safety, follow the installation instructions;
2.The product shall be installed in accordance with applicable regulations and rules, in compliance with safety
precautions during installation work;
3. Installation of the equipment shall be carried out with the power supply disconnected;
4. Packaging materials shall be disposed in accordance with applicable standards;
5. Strictly observe the sequence of operations for assembling the boom barrier specified in the instruction;
9. Appropriate warning signs, operating in the territory of the country, shall be placed on the section of traffic
regulated by boom barrier!
џ
Do not install this equipment during a lightning storm, heavy rain or snow, in an explosive
atmosphere and in poor visibility. Mounting zone is equipped according to the current
standards.
џ
Boom barrier installation, connection and commissioning works shall be performed by
specialists of the appropriate qualification.
6. If faults or defects are detected, contact the supplier's service service.
7. The installer shall provide the user with the necessary information on the operation of the system in manual mode
in case of an emergency.
8. Before handing over the product to the end user, check consistency of product indicators. Make sure that the
automation, security and unlocking of drive configured correctly.
The manufacturer is not responsible for the operation of equipment in the following cases:
џ
non-compliance with the installation technology,
џ
use of non-standard materials and components,
џ
performance of work by unqualified personnel,
џ
manufacturer is not responsible for the safety measures when installing the equipment by personnel not
involved in the company service department.
Page
-4-
Size А4
Installation and Operation Manual
Revision 1.0 2021
ROAD BLOCKING SYSTEMS
Office and Production site:
Tel.:
+380 (44) 291-21-11
14 Promyslova str., 02088, Kyiv, Ukraine,
Fax:
+380 (44) 291-21-02
E-mail:
sales@tiso.global www.tiso.global
BOOM BARRIER OPTIMUS
