16
3.1. Wire remote control panel RB111
Fig. 8 -
Front face of control panel
RB111
The wire remote control unit
RB111
can be used for the road blocker control.
In general the control panel can control two independent devices connected to one control unit.
Buttons
"1 UP"
,
"1 DOWN"
,
"1 STOP"
are used for the
road blocker
1 control.
Buttons
"2 UP", "2 DOWN", "2 STOP"
are used for the
road blocker
2 control.
Road blocker is raised when
"UP"
button is pushed. The lamp near
"UP"
button will be blinking
during raising. When road blocker reaches the uppermost position and stops, then the lamp near
"UP"
button will be steadily lit - UP position display.
Road blocker is sunk when
"DOWN"
button is pushed. The lamp near
"DOWN"
button will be
blinking during lowering. When Road blocker reaches the lowermost position and stops, then the
lamp near
"DOWN"
button will be steadily lit - DOWN position display.
Road blocker is stopped when
"STOP"
button is pushed during raising or lowering.
The remote control panel
RB111
is equipped with built-in road blocker movement alarm and produces
harmonic signals during road blocker raising and lowering.
The indicator
"Communication"
displays availability or lack of connection with control unit.
If it is green, then connection is available. If it is red, then connection is lack. When there is no
connection, then remote control panel produces pulsed sounds.
The indicator
"Trouble"
displays availability or lack of failure of remote control panel. If it is green, then
remote control panel is operating properly. If it is red, then remote control panel is operating improperly.