11 AUIA.123.00.00.00.00-05 OM
X1/12
+5 V
EXIT
Not applicable
X2/1
GRN1
EXIT
Not applicable
X2/2
RED1
EXIT
Not applicable
X2/3
GRN2
EXIT
Not applicable
X2/4
RED2
EXIT
Not applicable
X2/5
-MG1
EXIT
Not applicable
1) type of output – open
collector;
2) peak voltage on privacy
key – 50V;
3) peak current of public
key – 5A
X2/6
+MG1
EXIT
Not applicable
X2/7
-MG2
EXIT
Connection of electromagnetic
brake winding
1) type of output – open
collector;
2) peak voltage on privacy
key – 50V;
3) peak current of public
key – 5A
X2/8
+MG2
EXIT
Connection of electromagnetic
brake winding
(cathode of protective diode)
X2/9
MOT1
EXIT
Connection of motor
1) voltage (10÷27)V;
2) current ≤ 4А
X2/10
MOT2
EXIT
X2/11
GND
«-» of power supply
(common wire)
X2/12
+24V
ENTRY
«+» of power supply
(controller energizing)
1) voltage (10÷27)V;
2) current ≤ 4А
1.8.2
Turnstile controller РСВ.112.21.20.00
The controller РСВ.112.21.20.00 determines behavior of the whole turnstile.
1.8.2.1 Controller is assembled on card (104х68)mm and designed for installation into the turnstile
housing or power supply box.
19 LEDs are mounted on controller card. Their purpose is as follows:
5 LEDs initiate state of inputs for peripheral connections «INP1» ÷ «INP5»;
LED «POWER» initiates availability of power voltage 5V;
LED «OPERATE» initiates operability of microprocessor;
7 LEDs initiate state of outputs for peripheral connections «OUT1» ÷ «OUT7»;
LEDs «SENSOR» initiate state of rotor position sensor;
LEDs «RX» and «TX» initiate respectively reception and transmittance in serial port.
40 connecting terminals are mounted on card, 14 of which are designed for peripheral connections.
The rest of them are standby or designed for connection to the turnstile’s units.
The controller’s appearance is shown in the Figure 3.
1.8.2.2 Technical features
Controller technical features are specified in the Table 7.
Table 7
Parameter description
Parameter value
Number of inputs for reception of control commands
5
Number of inputs for connection of rotation sensors
7
Type of inputs
logical
Type of outputs
open collector
