Chronograph with alarm
*
www.tissot.ch
124_EN / 08.06
4/4
Chronograph (SPLIT function)
The SPLIT-TIME function enables you to stop the hands to read an intermediate time, without interrupting the
timing operation. When you restart, the hands « catch up » the lost time.
Crown in position I
START
SPLIT
Reading the time 1
RESTART (catchup)
SPLIT
Reading the time 2
RESTART (catchup)
STOP
Reading the last time
Reset counters to zero
Chronograph (LAP function)
This function enables you to time individual laps of a race.
Crown in position I
START (T1, T2)
LAP 1
Reading the time T1
RESTART (catchup)
LAP 2
Reading the time T2
RESTART (catchup)
Read the last time
Read the total time
Reset counters to zero
Time zones
Every time you change time zone, or move to daylight saving hours (summer to winter time or vice versa),
this watch enables you to synchronize the analog (hands) and digital times simultaneously while altering the
setting.
Crown in position II
Turn the crown until the watch displays the correct time. The digital time display alters automatically to
synchronize with the movement of the hands.
Note:
You also have to option of altering the digital time setting by pressing pusher
C
.
60
20
40
30
20
10
3
6
9
D
C
B
A
1
6
3
2
5
4
7
60
20
40
30
20
10
3
6
9
D
C
B
A
1
6
8
4
5
3
2
7
I
D
C
B
A
Care and maintenance
We would advise you to clean your chronograph regularly (except for the leather strap) using a soft cloth and warm soapy water. After immersion in salty water,
rinse it in fresh water and leave it to dry completely. Do not leave it anywhere where it might be subjected to major variations in temperature or humidity, in direct
sunlight or near strong magnetic fields.
To benefit from the highest standards of service and to ensure your guarantee remains in force, please always contact an approved TISSOT
®
representative or
retailer.
TISSOT
®
Quartz chronographs
benefit from the incomparable precision of quartz. Their power reserve usually enables them to operate for more than 2 years in
continuous use. If you envisage not wearing your chronograph for several weeks or months, we would advise you to put it to one side with the crown pulled out
into position
II
. This cuts the electrical power supply to the motor, thereby extending battery life considerably.
Replacing the battery
Once the battery has run flat, it must be replaced without delay by an approved TISSOT
®
representative or retailer.
Type : High impedance / SR 936 PW / Renata 394.
Collection and treatment of end of life quartz watches*
This symbol indicates that this product should not be disposed with household waste. It has to be returned to a local authorized collection system. By
following this procedure you will contribute to the protection of the environment and human health. The recycling of the materials will help to conserve
natural resources.
* valid in the EU member states and in any countries with corresponding legislation.
Chronograph (ADD function)
The ADD function enables you to measure consecutive events without having to reset to zero between each
event. Each time recorded is simply added to the previous total.
Crown in position I
START
STOP
Reading the time
RESTART
STOP
Reading the time
Reset counters to zero
60
20
40
30
20
10
3
6
9
1
2
3
4
x
D
C
B
A
I
