11
Bottom End of Carriage
ATTENTION
cable stud goes through
the big hole then moves
to small end
big hole end
small hole end
cable stud
equalizing cable
adjusting
window
cable stud
Upper End of Carriage
Fig. 9
Fig. 11
Fig. 10
Fig. 12
14) Adjust the carriage cable tension. This is accomplished by tightening the lock nut under
the upper end of each carriage through the adjusting window.
Tighten the nut on the
side that you wish to raise.
Adjust each cable to approximately 1/2” side-to-side play.
When the cables are adjusted properly, the locks will click simultaniously as the lift is
raised.
15) Install the swing arms on the carriages using the included 4 pins (35). Adjust the lifting
arm gear locks on each swing arm. Check for proper engagement of the arm lock – the
rack on the lock should fully engaged in the gear on the arm.
connect
according
to the
instructions
safety
switch
fixing bolt
wire for
ceiling safety
device
lowering handle
outlet port
up button
small hole for
wire exit
