7. Using 4 x 16mm bolts fix bracket into place. Use
washer above and below bracket and spring washer
underneath.
8. Remove adjustment bolt and lever (above left) and slide handlebars onto handrail stand. Replace
bolt ensuring that the bolt goes into hexagonal hole (above middle). Tighten with lever to adjust to
desired position.
9. Screw ignition switch onto handlebars
and connect terminal block as shown
(right)
A
10.
A Gear shift lever with cotterpin attached
B Remove cotterpin and slide lever through hole
C Attach the lever to the gear shift selector and replace pin
B
C
