Titan 0290008 Owner'S Manual Download

Page: 10 / 64

English

Adjusting the Trigger Tension

Use the following procedure to adjust the spring tension of the

trigger lever on the gun holder assembly. The trigger lever pulls and

releases the spray gun trigger when operated from the trigger on the

cart. The proper tension ensures that the gun will shut off when the

gun trigger is released. To ensure proper tension, there should be

approximately a 1/32” to 1/16” gap between the trigger lever and the

spray gun trigger.
ImPORTANT: Always keep the trigger lock on the spray gun in

the locked position while making adjustments to the system.
1. Using a wrench, loosen the bolt on the cable block.
2. Move the cable block in the appropriate direction to create a

gap of 1/32” to 1/16” between the trigger lever and spray gun

trigger.

a. Slide the cable block toward the gun to increase the gap between

the trigger lever and spray gun trigger.

b. Slide the cable block away from the gun to decrease the gap

between the trigger lever and spray gun trigger.

Spray Gun

Trigger

Trigger Lever

1/32" to 1/16" Gap

Cable Block

(bolt on back)

3. Tighten the set screw securely.

Replacing the PRImE/SPRAy valve

Perform the following procedure using PRIME/SPRAY valve

replacement kit P/N 800-915 or 700-258.
  1.  Drive the groove pin out of the valve handle.
  2.  Remove the valve handle and the cam base.
  3.  Using a wrench, loosen and remove the valve housing

assembly from the pump manifold.

4. Make sure the gasket is in place and thread the new valve

housing assembly into the pump manifold. Tighten securely

with a wrench.

5. Place the cam base over the valve housing assembly.

Lubricate the cam base with grease and line up the cam with

the pump manifold using the dowel pin.

6. Line up the hole on the valve stem with the hole in the valve

handle.

7. Insert the groove pin into the valve handle and through the

valve stem to secure the valve handle in position.

Dowel Pin

Groove Pin

Valve Stem

Gasket

Pump

Manifold

Valve Housing

Assembly

Valve

Handle

Cam Base

cleaning or Replacing the Filters

Pump Filter

1. Loosen and remove the filter housing by hand. Pull the filter

out of the pump manifold.

2. Slip the filter off of the filter support spring.
3. Inspect the filter. Based on inspection, clean or replace the

filter.

4. Inspect the filter seal. Based on inspection, clean or replace

the filter seal.

5. Slide the new or cleaned filter over the filter support spring

with the adapter in place. Push the filter into the center of the

pump manifold.

6. Slide the filter housing over the filter and thread it into the

pump manifold until secure.

NOTE: The filter housing should be hand-tightened, but

make sure the filter housing is seated fully into the

pump manifold.

Filter

Spring

Adapter

Filter Support Spring

Filter Seal

Pump Manifold

Filter

Housing

Gun Filter

  1.  Move the gun trigger lock to the unlocked position.
  2.  Loosen and remove the handle from the gun body.
  3.  Turning clockwise, unscrew the filter from the gun body.

NOTE: Left-handed threads require turning the filter

clockwise to remove.

4. Turning counterclockwise, screw the new or cleaned filter into

the gun body.

5. Make sure the handle seal is in position and thread the handle

into the gun body until secure.

6. Move the gun trigger lock to the locked position.

Gun

Housing

Filter

Handle

Seal