English
English
© Titan Tool Inc. All rights reserved.
9
maintenance
Before proceeding, follow the Pressure relief
Procedure outlined previously in this manual.
additionally, follow all other warnings to reduce the
risk of an injection injury, injury from moving parts
or electric shock. always unplug the sprayer before
servicing!
General repair and Service Notes
The following tools are needed when repairing this sprayer:
Phillips Screwdriver
3/8” Hex Wrench
Needle Nose Pliers
5/16” Hex Wrench
Adjustable Wrench
1/4” Hex Wrench
Rubber Mallet
3/16” Hex Wrench
Flat-blade Screwdriver
5/32” Hex Wrench
5/64” Hex Wrench
1. Before repairing any part of the sprayer, read the instructions
carefully, including all warnings.
ImPOrTaNT: Never pull on a wire to disconnect it. Pulling on a
wire could loosen the connector from the wire.
2. Test your repair before regular operation of the sprayer to be
sure that the problem is corrected. If the sprayer does not
operate properly, review the repair procedure to determine if
everything was done correctly. Refer to the Troubleshooting
Charts to help identify other possible problems.
3. Make certain that the service area is well ventilated in case
solvents are used during cleaning. Always wear protective
eyewear while servicing. Additional protective equipment
may be required depending on the type of cleaning solvent.
Always contact the supplier of solvents for recommendations.
4. If you have any further questions concerning your Titan Airless
Sprayer, call Titan:
Customer Service (U.S.) ..................................... 1-800-526-5362
Fax
................................................................. 1-800-528-4826
replacing the Filters
Pump Filter
Filter Body
Filter Spring
Filter Spring
Adapter
Core Spring
Filter
O-ring
Filter Housing
1. Loosen and remove the filter
body by hand.
2. Slip the filter off of the core
spring.
3. Inspect the filter. Based on
inspection, clean or replace the
filter.
4. Inspect the o-ring. Based on
inspection, clean or replace the
o-ring.
5. Slide the new or cleaned filter
over the core spring with the
filter spring adapter in place.
Push the filter into the center of
the filter housing.
6. Slide the filter body over the
filter and thread it into the filter
housing until secure.
NOTE: The filter housing
should be hand-
tightened, but make
sure the filter housing
is seated fully into the
pump block.
Gun Filter
1. Move the gun trigger lock to the unlocked position.
2. Loosen and remove the handle from the gun body.
3. Turning clockwise, unscrew the filter from the gun body.
NOTE: Left-handed threads require turning the filter
clockwise to remove.
4. Turning counterclockwise, screw the new or cleaned filter into
the gun body.
5. Make sure the handle seal is in position and thread the handle
into the gun body until secure.
6. Move the gun trigger lock to the locked position.
Handle
Handle
Seal
Filter
Gun
Body
NOTE: For more detail, part number information, and
complete assembly drawings, please see the LX-80II
Professional airless Gun Owner’s manual (P/N 313-
2293).