Getting
started...
GB
IE
Before you start
19
> Pay attention to the rotational direction indicated on the inside of the sanding
belt (2). Align the sanding belt (2) in accordance with the direction indicated on
the product housing and slide it over the front roller (1) and the drive roller (6)
(Fig. 2, step 2).
> Press the clamp lever (4) back in. Slightly pull on the sanding belt (2) to test if
it sits properly in place (Fig. 3).
1
4
6
2
2.
1.
4
2
Fig. 2
Fig. 3
Belt position
> Make sure the on/off switch (12) is in its off position. Then connect the plug with
a suitable socket.
> Hold the product securely and press the on/off switch (12) then release it.
The sanding belt rotates for a short period to check the correct position.
NOTE:
Refer to “Product functions / Operation” for more information
about operating this product!
> Whilst the sanding belt is running, adjust the tracking adjustment knob (5) to
align the sanding belt to the centre of the rollers (1, 6).
> Turn the tracking adjustment knob (5) clockwise to adjust the sanding belt (2)
to the right (Fig. 4).
> Turn the tracking adjustment knob (5) anticlockwise to adjust the sanding belt
(2) to the left (Fig. 5).
TTB910SDR
by TITAN
