4
© Titan Tool Inc. All rights reserved.
English
Introduction
Atomize
d
Material
Pattern Air
(flat tip only)
Atomizing
Air
In the air assisted/airless spraying process, the spraying material is atomized at pressures between 400
– 1800 PSI (3 – 12.4 MPa). The atomizing air at 7 – 32 PSI (0 – 0.22 MPa) produces a soft spray jet that
eliminates problems of overlaps in the boundary zone. The soft spray jet prevents the spraying material
from rebounding to the gun. The form air reduces or increases the spray jet width, depending on the
adjustment of the air adjustment knob. Due to the cleaning-friendly design of the tip and the lack of air
holes near the material outlet, the tip is virtually self-cleaning.
When the trigger of the gun is pulled, the air valve opens allowing atomizing and fan jet air to flow up to
the tip. The material valve opens only when the trigger is pulled to its fullest extent.
The amount of air for the spray jet width is adjusted using the air adjustment knob. The air input should
be adjusted at the source to approximately 0 – 32 PSI (0 – 0.22 MPa).
Gun Hook
Tip Guard
Trigger
Material and
Filter Tube
Material Inlet Fitting
Model 0524358
Model 0524357
Air Inlet Fitting
Trigger Lock
Trigger Lock
Air Adjustment
Knob
Gun Hook
Gun Body
Gun Body
Tip Guard
Reversible Tip
Flat Tip
Trigger
Material and
Filter Tube
Material Inlet Fitting
Air Inlet Fitting
Air Adjustment
Knob
advantages of the adjustable air assisted/airless process:
• high coverage capability
• low overspray
• fine finish
• adjustability of spray pattern width
Materials that can be sprayed using this gun include:
• Water, oil, and solvent based primers and topcoats
• Fine finishing enamels and automotive coatings
• Release agents