© Titan Tool Inc. All rights reserved.
5
English
English
Preparation
1. Make sure trigger lock is activated.
Trigger lock activated
(gun will not spray)
2. Connect one end of the material hose to the spray gun,
and the other end to the pump.
3. Connect one end of the air hose to the spray gun, and the
other end to the air supply.
Connect
air hose
Connect
material hose
4.
Model 0524358 only
- Place the tip into the tip seal. Fit
the air cap over the tip, making sure that the location flats
(inset) are in line.
Flats
Tip
Tip
Air Cap
Air Cap
Tip Seal
5. Place the tip guard over the air cap and tighten.
Operation
1. Start up the spray unit (refer to the spray unit’s Owner’s
Manual).
2. Adjust the material pressure at the pump to approximately
400 PSI (3 MPa).
3. Unlock the spray gun. Pull the trigger and increase the
pump pressure until the spray pattern is acceptable.
4. Open the atomizing air at the external air regulator and
adjust the air pressure to the best spray pattern (to a
maximum of 32 PSI (0.22 MPa)). The form air may be
adjusted using the air adjustment knob to the required
spray jet width.
IMPORTaNT: Do not turn the air adjustment knob using
pliers. Over-tightening and damage to the gun may occur.
adjusting the Spray Pattern
The spray pattern can be adjusted to suit the object being
sprayed by using the air adjustment knob. The illustration below
shows how the air adjustment knob can control the spray pattern.
Other nozzle sizes can be used to obtain larger or smaller
spraying patterns.
Rear of gun
Knob fully
open
Knob fully
closed
cleaning / Replacing the Tip (model 0524358 only)
If your spray pattern becomes distorted or is inadequate, you
may need to clean or replace the tip or air cap.
IMPORTaNT: Do not use any sharp, metal objects when
cleaning the tip.
1. Relieve spray gun and unit pressure.
2. Lock the spray gun by activating the trigger lock.
3. Remove tip guard.
4. Press the tip out of the air cap by hand. Clean with
appropriate cleaning solvent and a soft-bristled brush until
all paint residue is removed.
5. Replace tip into tip seal.
6. Fit the air cap onto the tip, making sure that the location
flats are in line.
7. Replace tip guard.
Tip
Air Cap
Tip Guard
Tip Seal
