12
DESCRIPTION OF UNIT
HYDRA X
3.6
TRANSPORTATION
TRANSPORTATION IN VEHICLE
Secure the unit with a suitable fastening.
CRANE TRANSPORT
Hanging points for crane straps or ropes, see figure 3 below.
The motor/pump lift should be in the fully retracted (down)
position before lifting the unit.
i
The machine weighs approximately 390 pounds.
Follow relevant OSHA standards for lifting.
www.osha.gov
Make sure the strap or rope is behind the
hydraulic tube (located on the right front of
the unit, when facing the front) so that it is not
crushed.
3.7
ELECTRONIC CONTROLS
MASTER POWER SWITCH
The master power switch provides electrical power to the
entire system. Press and hold the button for 3 seconds to turn
electrical power ON. Press the button once to turn electrical
power OFF.
LIFT SWITCH
The lift switch raises and lowers the hydraulic motor/fluid
section of the unit. The master power switch must be switched
ON in order for the lift switch to be functional.
If the lift switch is held in the UP position for three seconds (and
then released) the lift mechanism will automatically extend to
the highest position and then stop, or the operator can push
the switch down to keep the lift from going up any further.
The lift can push the tube far enough to lift the front of the
machine. This will not damage the machine.
ENGINE KEY IGNITION
The engine key ignition switches the engine ON and OFF. Turn
the key all the way to the right to turn on the engine whenever
prompted.
