14
COMMISSIONING
PowrMax
6.5
SPRAY ATTACHMENT ASSEMBLY
(ACCESSORIES)
i
Different accessories can be mounted to the
spray lance, depending on the application, e.g.
an extension can be attached. A precise overview
can be found in the “Accessories” chapter.
1. Disengage the quick connector and pull the air hose (fig. 8,
1) out of the lance.
2. Loosen the locknut (2) and remove the material hose (3).
1
3
2
3. Insert the material hose and air hose (if available), which
are part of the accessory, into the spray lance and secure
by tightening the locknut. (Fig. 9)
Attention
Make sure the O-ring (fig. 9, 4) is not damaged.
4
6.6
CONNECTING THE SPRAY LANCE (FIG. 10)
1. Select a spray tip suitable for the material:
The tip size should amount to at least three times the
granular size, e.g.
granular size artificial resin plasters –> 3 mm
Tip size –> 10 mm
2. Mount the texture tip (1) in the spray lance with the cone
pointing towards the spray head.
3. Connect the spray lance (2) to the material hose and secure
by applying the levers (3).
4. Close the material tap (4) (material tap points forwards).
5. Connect atomization air connection (5) to the air hose of
the mortar hose.
6. Screw coupling plug (6) for remote control to the control
cable of the mortar hose.
2
4
1
3
6
5
7. Connect mortar hose‘s control cable to pump connection.
(Fig. 11)
8. Set selector switch to “A”.
REMOTE
Control
ELEC
PNEUM
Controler
