4
© Titan Tool Inc. All rights reserved.
English
English
Operation checklist
You have received a
SpeeFlo powrDriver in working condition
shipped complete.
Please attach to your equipment before operating and confirm
the following.
1. Your equipment mounts properly for safe operation
2. Review the pre-operation check as follows:
a. Check engine oil.
b. Check Transmission oil.
c. Fill Fuel with non-leaded gas in tank.
d. Check tire pressure.
3. Review operation of Sulky
4. Sit on unit and move seat to correct position and lock
5. Reach around and locate choke lever.
Normally choke to start. Then idle and warm up as you
unchoke.
6. push pedal slowly forward to begin forward motion.
7. Adjust engine speed and amount of pedal pressure to
regulate speed.
NOTE: Pushing the pedal forward to increase power
does not work.
Torque is actually increased by bringing pedal
back closer to neutral.
IMPORTaNT: Running machine at wide open is not advised
and may overheat components.
NEvER dismount unit
with the engine running.
Maintenance
Read below in order to know what type of maintenance should
be performed on your SpeeFlo powrDriver at certain intervals
of usage.
Daily:
• Check engine oil level and fill as necessary. See
manufacturers specs for ApI rating.
• Check hydraulic oil transmission reservoir level and fill as
necessary.
• Check and fill the gas tank with regular unleaded gas.
• Check tires and inflate to 25 PSI if needed
• Start engine and allow to idle. Test forward, reverse, and
neutral position. If off rotate centering, adjust tensioning
knob.
• Wipe down equipment – Never use a water hose to wash.
• Check and clean air cleaner. Replace when necessary
• Check tires for correct inflation
After first 20 hours:
• Drain and refill engine oil with SAE 10W-30 oil. See
manufacturers specs for ApI rating.
Weekly:
• Spray chain with Dry Motorcycle Chain Lube.
• Grease Axle Bearings – Moly type grease, two pumps of
grease gun. Wipe excess grease off bearings.
• Add a small amount of grease to ball coupler inside ball
area.
• Check all hardware for integrity. Tighten any loose bolts or
nuts.
Every 50 hours:
• Drain and refill engine oil with SAE 10W-30 oil. See
manufacturers specs for ApI rating
Every 100 hours:
• Replace SPARK PLUG
• Inspect system for oil leakage from drive assembly.
• Check and refill if necessary Transmission reservoir.
• Check Chain tension and reset idler sprocket to tension
if required. Remove transmission cover and check drive
belt. Re-tension if required.
• Use air supply to remove accumulated dust inside cover.
