Operation
-----------------------------------------------------------------------------------------------------------------------------------------
■
STARTING ENGINE
WARNING
The cutting head will start rotating upon the
engine starts.
1. Rest the unit on a flat, firm place. Keep the
cutting head off the ground and clear of
surrounding objects as it will start rotating upon
starting of the engine.
2. Push the primer pump several times until
overflown fuel flows out in the return tube.
(OP1)
3. Move the choke lever to the closed position.
(OP2)
(1) Choke lever (2) Closed position
(3) Open position
4. Set the ignition switch to the “start” position.
While pulling the throttle lever, push the throttle
set button, and release the throttle, then the
throttle lever is into the “Start position. (OP3)
(1) Ignition switch (2) Stop
(3) Start
5. While holding the unit firmly, pull out the
starter rope quickly until engine fires. (OP4)
IMPORTANT
• Avoid pulling the rope to its end or
returning it by releasing the knob. Such actions
can cause starter failures.
6. Move the choke lever to the open position
(OP2). And pull out the starter rope quickly to
restart engine. (OP4)
7. Allow the engine to warm up for several
minutes before starting operation.
NOTE
2.
When restarting the engine immediately
after stopping it, leave the choke open (OP2)
and push the primer pump several times
(OP4).
