Maintenance
-------------------------------------------------------------------------------------------------------
Maintenance, replacement, or repair of the
emission control device and systems may be
performed by any non-road engine repair
establishment or individual.
WARNING
•
Always be sure to stop the engine before
inspecting the brush cutter for problems or
performing maintenance.
•
Never alter the brush cutter or take the
engine apart.
•
Things to check before using brush cutter.
■
REFILLING TRIMMING LINE
1. For replacement line, use a diameter of
2.4mm (.095in). The spool is capable for a line up
to 6m (20ft) on the 10cm (4”) head. Avoid using
a larger line as it may cut down the trimming
performance.
WARNING
•
For
safety
reasons,
do
not
use
metalreinforced line.
2. Pinch the slotted area on the both sides of the
spool housing to unhook the bottom cap.
3. Take out the spool and pull off the old line. Put
one end of new line through the spool holes and
pull it until the length is equal between each part
of the line.
4. Wind up the line in the correct direction as
indicated on the spool.
5. Hook each end of the line in the slot on the
edge of the spool, and then put the ends
through the eyelets on the housing. Make sure
that the spring and the washers are in place.
6. While holding the spool against the housing,
pull the line ends to release them from the slot.
7. Line up the slot on the bottom cap with the
hook on the housing, press the cap against the
housing until it clicks.
