You are advised to consider the risks associated with the materials you
are working with and to reduce the risk of exposure. You should:
- Work in a well-ventilated area.
- Work with approved safety equipment, such as those dust masks that are
specially designed to filter microscopic particles.
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR TOOLS
> Do not operate your machine until it is completely assembled and installed
according to the instructions.
> If you are not thoroughly familiar with the operation of abrasive finishing
machines, obtain advice from your supervisor, instructor or other qualified
person.
Caution:
This machine is designed to sand wood or wood-like products
only. Sanding or grinding other materials could result in fire, injury or
damage to product.
> Always wear eye protection.
> This MACHINE is intended for indoor use only.
Important:
Mount and use this machine on horizontal surfaces only.
Operating machine when mounted on non-horizontal surfaces might result
in motor damage.
> If there is any tendency for the machine to tip over or move during certain
operations such as when sanding long or heavy boards, the machine must
be securely fastened to a supporting surface.
> Make sure the sanding belt is tracking correctly in order that it does not run
off the pulleys.
> Make sure the sanding belt runs in the proper direction. See directional arrow
on back side of belt.
> Make sure the sanding belt or disc is not torn or loose.
> Support workpiece firmly with the miter gage, backstop or work table when
sanding with the belt.
Note:
The only exception is curved work performed on the top wheel of
belt.
> Always hold the workpiece firmly on the table when sanding on the disc.
> Avoid kickback by sanding in accordance with directional arrows. Sand on
downward side of disc. Sanding on the upward side could cause the workpiece
to fly up causing injury.
> Always maintain a minimum clearance of 1/16” or less between the table or
backstop and the sanding belt or disc.
> Never wear gloves or hold the work with a rag when sanding.
> Sand with the grain of the wood.
TTB546BTS
by TITAN
Getting
started...
GB
10
IE
Technical and legal
information
