Fig. 2
Fig. 3
Before you start
> Unplug the tile cutter from the mains supply.
> Raise the 45° Vertical fence (1) approx. 45° and remove.
> Loosen screw (19) and pull off lower protective guard (6).
TTB903TCH
by
TITAN
Getting
started...
13
Fitting the cutting disc
1
19
6
WARNING: Product damage!
Be sure to observe the rotational direction of the cutting disc when
fitting! Be sure to observe the free-wheeling of the cutting disc when
fitting!
NOTE:
When fitting make sure that the cutting disc is placed correctly
on the inner flange. The inner flange can be moved freely on the
motor shaft and has a section for holding the internal hole of the
cutting disc. The hole of the outer flange is not round and is used
for the interlocking connection with the motor shaft.
EN
Summary of Contents for TTB903TCH
Page 39: ......
