TitanCut 40
PFC
Operators Manual
Issue. A 0516
CUTTING MACHINES ARE CONTACT START, THE PLASMA ARC IGNITED
IMMEDIATELY AFTER START SWITCH CLOSED. ALWAYS HOLD THE HAND TORCH
AWAY FROM YOUR BODY AS A PRECAUTION AGAINST ACCIDENTAL TORCH FIRING.
BE AWARE OF THIS HAZARD. FAILURE TO DO SO CAN RESULT IN SERIOUS BODILY
INJURY.
3-1.6
Evenly move the torch in the desired direction, at a speed which will ensure good cut quality.
When using shielded consumables, drag the torch tip directly on the work piece.
3-1.7
Hold the torch lightly on the metal or just above metal. Holding the torch firmly to the work piece
causes the shield to stick and makes smooth cutting difficult. Pulling the torch through the cut is
easier than push it.
3-1.8
When the cut is finished, release the torch switch to extinguish the arc.
3-1.9
After finish operation, turn off the gas valve, push torch switch to clear the residual gas in the
regulator. In the end, turn off welding power source and wall switch.
Turn on
the power
source
Loose the
cutting torch
switch
the torch
leaves the
workpiece,
the cutting
arc change
into pilot arc
again
Press on the
cutting
switch
Ignite the
pilot arc
Post-gas for
10s
Shift to the
workpiece, the
pilot arc change
into cutting arc
Arc
extinguished
Summary of Contents for 40 PFC
