•
Check each time before and after use, after a fall or other impacts to identify any significant
damage.
Do not use the tool in case of damage. Bring it to a qualified service agent for inspection and
reparation.
•
Risks and problems may occur during the operation, follow the instructions in this manual to
reduce these risks.
•
If the machine or cutting attachment needs to be unlocked, stop using the tool, remove the spark
plug. Wear safety protection to unlock the tool.
•
Do not work prolonged with the tool, take regular breaks during the operation.
•
Always keep a correct posture, do not use the tool in a position that could create accidents.
Secure the machine during transport to prevent loss of fuel, damage or injury. Always put the
protection devices on the blades. Always transport the tool upright.
Put the protection on the blade when storing the tool.
Hazards which could be encountered while using the machine (bump a foreign object, blockage of
the cutting attachment, etc.). In order to avoid hazards, inspect thoroughly the working area;
remove all hazardous material and object which may be present.
Kickback and Related Warnings
-
Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, brush or any
other accessory. Pinching or snagging causes rapid stalling of the rotating accessory which in turn
causes the uncontrolled power tool to be forced in the direction opposite of the accessory’s rotation at
the point of the binding.
-
For example, if an abrasive wheel is snagged or pinched by the workpiece, the edge of the wheel
that is entering into the pinch point can dig into the surface of the material causing the wheel to climb
out or kick out. The wheel may either jump toward or away from the operator, depending on direction
of the wheel’s movement at the point of pinching. Abrasive wheels may also break under these
conditions.
-
Kickback is the result of power tool misuse and/or incorrect operating procedures or conditions
and can be avoided by taking proper precautions as given below:
o
Never place your hand near the rotating accessory. Accessory may kickback over your hand.
o
Do not position your body in the area where power tool will move if kickback occurs. Kickback will
propel the tool in direction opposite to the wheel’s movement at the point of snagging.
o
Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the
accessory. Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and cause
loss of control or kickback.
Residual risks
Even if you use this tool correctly, there are always residual risks. The following hazards may arise in
connection with the structure and manufacture of this power tool:
-
Hearing impairment if no suitable hearing protection is worn.
-
Cuts if no suitable protective clothing is worn.
-
Health damage resulting from vibration in the hands and arms if the device is used for a long
period of time or is not handled and maintained properly.
-
Inhalation of particles
-
Inhalation of exhaust gases
-
Skin contact with oil / gasoline
-
Inhalation of gasoline / oil vapors
-
Contact with projected objects
-
Burns when touching with hot surfaces
-
Prolonged use of this product exposes the operator to vibration and can produce so-called "white
finger" disease. To reduce the risk, wear gloves and keep your hands warm.
-
If any of the symptoms of "white finger syndrome" occur, seek immediate medical attention.
Symptoms of the "white finger" include numbness, loss of sensitivity, tingling, pain, loss of strength,
Summary of Contents for XT-BC508-1
Page 1: ...XT BC508 1 ...
