INSTALLATION (Tools Required)
DRILL
1/4” NUT RUNNER
5/16” DRILL BIT
1/4” WRENCH
SCREW DRIVER
TIN SNIPS
NOTE:
If installing the DUCT BOOSTER® on a flat duct, the housing
flanges will have to be bent at a 90
O
angle before inserting DUCT
BOOSTER® into duct. This will allow screws to better align with the
speed clips provided.
1. Opening should be cut in the bottom or top of a horizontal duct or any side of
a vertical duct. The motor shaft will then be in the horizontal position. Apply
the mounting template provided to the duct, cut opening and drill four 5/16”
holes noted on template.
WIRING DUCT BOOSTER
®
IN PARALLEL WITH HEAT CYCLE
OR COOLING/BLOWER “ON” CYCLE
